How To Right-Size Your Wireless Testing

May 5, 2017/in Application Notes/by JFW Eng Dept

This application note discusses the challenges of choosing new RF test equipment for wireless testing. Depending on whether you are testing military radios or wireless cellular equipment, there are many different testing configuration options for selection. Picking the right size and configuration for your RF test system is critical. Feel free to email our engineering department if you have any questions.

Recent Posts

32 Attenuator Assembly for CATV Automated Testing | DC-1218MHzNovember 4, 2024 - 1:38 pm
JFW model 75PA-131 F is a 75 Ohm attenuator assembly that can be used to test CATV devices. The attenuator assembly operates DC-1218MHz and contains 32 individually controlled step attenuators with attenuation range 0-95.5dB x 0.5dB steps. Each attenuator has two ports that are both cabled to the rear panel with F female connectors. The […]
2 Watt Termination with TNC male or female | DC-18 GHzNovember 4, 2024 - 12:53 pm
JFW model 50T-706 is a 50 Ohm termination that operates DC-18GHz. It is available with TNC male or TNC female. It is rated for 2 Watts average input power. Schematically this part is a 50 Ohm resistor to ground. Connecting this part to an open 50 Ohm port will properly terminate the port with 50 […]
6X6 Blocking Matrix Switch | 400-7125 MHzOctober 29, 2024 - 10:59 am
JFW model 50MS-471 is a 6X6 blocking matrix switch that operates 400-7125 MHz. All unused ports are absorptive (i.e. self-terminating into 50 Ohm). It is available with N or SMA connectors. The matrix is constructed using switches on both halves of the matrix. A 6X6 blocking matrix can only have a maximum of 6 active […]

How To Right-Size Your Wireless Testing

Product Search

Resources

Products

Contact